← All Problem Solvers ESPHome · OpenBeken · Tuya · BK7231 · ESP32 · PINOUTEXTRACT

$39 Flat

Extract Safe ESPHome / OpenBeken GPIO Pinout From Smart-Appliance Flash Dump

✓ 5 sec in RAM · 0 Bytes Stored · 1-Click Instant Refund

Failure Prevented: Blocks boot-high pin glitches from firing 2200W heaters dry on reboot + adds 92C thermal cutoff.

1. Read Own Device Partition: Read the user_param / KV string from your BK7231 or ESP32 module via ltchiptool / esptool.

2. Drop Snippet or JSON: Paste the extracted JSON/hex configuration string into the box above.

3. Audit Boot Pins: Check if any relay or heater sits on a boot-strapping pin before flashing.

Drop Factory KV/JSON Partition Header or GPIO/DPID Table (.json, .txt, .csv, .yaml)

Pre-Pay Deterministic X-Ray · 3 Structural Defects Caught SHA-256: — · Confidence: 99.4%

Verified Ready Package: Boot-Glitch-Safe ESPHome YAML + OpenBeken Pin Map + DPID Schema (.yaml)

Done! Where to upload / apply your fixed file (30s):

1. Flash ESPHome / LibreTiny: Paste the downloaded YAML into ESPHome Dashboard and compile firmware.

2. Verify Interlocks: Confirm restore_mode: ALWAYS_OFF and NTC thermal cutoff sensor readouts in logs before mains load.

3. Keep Backup: Store OpenBeken JSON alongside your original flash dump for instant rollback.

Merchant of Record: Paddle.com Market Ltd · Automated VAT/Tax in 200+ Countries < 0.8s Automated POST /adjustments Refund · Zero Human Support